Husky 10-26K Instructions D'installation page 5

Prior to assembly of "HUSKY 10-26K", be sure that your base rails are properly installed and square with
each other. Measure diagonally across the rails. See Figure 1. Measurements "X" & "Y" should be within
3/16" of each other. These measurements are required for proper fit and function of the "HUSKY 10-26K".
2. Install the Husky Center Bolt kit using the parts provided in this kit.
3. Locate the center hole in each base rail. See Figure 1. Using these holes as a guide, drill a 5/8"
hole through the truck bed. Confirm that the fuel tank, brake/fuel lines, electrical wires located
under the bed are not in the path of drilling the holes in this step.
4. Drop the 5/8 carriage bolts supplied through the center bolt locations, through the truck bed.
5. Check the corrugations in the truck bed floor and place the spacer plate in the correct position as
shown. See Figure 2.
March 15, 2012-REV 5
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual
See www.huskytow.com for Warranty Information / Tech Support
Page 5 of 16