Husky 10-26K Instructions D'installation page 8

5. Insert handle assembly into hole on outside of driver side housing and secure with 3/8"
bolts, flat washers and lock washers and tighten to 30 lbs.-ft. You will have to twist the
handle assembly to get the curved plate through the rectangular slot in the housing.
CURVED PLATE
6. Screw compression cylinder assembly into threaded end of clevis/yoke on driver side
assembly until end of threaded rod is flush to inside of clevis/yoke; tighten jam nut.
Note: The retaining clip for the compression cylinder must face the pivot stop as shown.
Inside of
clevis/yoke.
End of
threaded rod.
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual
March 15, 2012-REV 5
Compression
cylinder assembly
Retaining clip for
compression cylinder.
See www.huskytow.com for Warranty Information / Tech Support
Page 8 of 16