Assembly Instructions - Rotel U753CH1 Mode D'emploi

 ASSEMBLY INSTRUCTIONS
o
The fan is packaged with its base and/or other parts unattached. You must attach
them before operating the fan.
o
WARNING: Never operate without its base and/or other parts attached. Do operate
the fan only in upright position; any other position could create a hazardous situa-
tion.
o
Assemble sequence of the base and other parts as follow:
 Unpack the fan and remove all the parts from the packaging.
 Use the bend bolt and the press plate provided to attach the stand post assem-
blies to the base.
 Adjust the lift pole to the desired length, then lock it with the locknut for lifting.
 Loosen the locknut for switch case and insert the lift pole into the hole located
on the bottom of the switch case in place, then fasten the locknut tightly.
 Take off the motor shaft cover from the fan
head and revolve the triangle screw off,
then take off the fan tie on the back grill
and let three columns into the three holes
in place fully. Finally tighten the triangle
screw counterclockwise.
 Let the notch on the back of the big fan
blade stuck in the stopper pin of the motor
shaft, and then tighten the small fan blade
counterclockwise.
 To attach the front grill to the back grill, use
the grill ring carefully to hold them together
and fasten the grill ring with the screw pro-
vided.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
25