Battery Charge - Nilox DOC E-BIKE X1 Manuel D'instructions

PEDAL ASSIST SYSTEM (PAS)
The button for activating the pedal assist system is on the right hand side of the handlebars.
THE PEDAL ASSIST FUNCTION CANNOT BE ACTIVATED WITH THE BICYCLE AT A STANDSTILL.
PAS operation:
• Pedal and simultaneously activate the PAS. This method entails a greater use of current and a
greater wear of the motor.
• Pedal until you create a certain inertia for the bicycle, activate the PAS and resume pedalling.
This method on the other hand allows greater savings in current and therefore a greater
protection of the motor.
Avoid sudden changes of speed.
•
• The current regulator automatically cuts off the electricity supply in the event of overvoltage,
re-establishing it when the electrical load is restored.
• Do not use the PAS in the rain or on excessively uneven ground.
• Turn off the PAS before stopping DOC E-BIKE X1, the last few pedal strokes should therefore
be made without electrical assistance.
BATTERY

BATTERY CHARGE

FRONT LIGHT
DOC E-BIKE X1 is equipped with a 5-LED torch powered by common
alkaline batteries.
EN
The battery of the DOC E-BIKE X1 can be charged:
• Directly on the bike, without taking the battery out.
• Taking the battery out and taking it home or to a place equipped with
electrical outlet.
Insert the power supply plug into the power inlet, placed on the side
battery and then plug the battery charger into the mains.
If the red light on the power unit comes on, the battery is low. If the
green light is on, this means charging is complete.
6