Battery Assembly; Brake Adjustment - Nilox DOC E-BIKE X1 Manuel D'instructions

BATTERY ASSEMBLY

Insert the battery in its housing as shown in the figure.
The fitted battery will look as shown in the figure.

BRAKE ADJUSTMENT

The brake levers are made of aluminium alloy.
Next to the brake lever is a cylinder to adjust the tension of the
wiring.
During braking, the electrical part of the motor is automatically
disabled.
The brakes are classic V brakes.
BRAKE CALIBRATION
EN
Gently push upwards so the battery fit into its housing.
Use an Allen wrench to adjust the angle of the braking unit and a
cross-tip screwdriver to adjust the distance of the brake pads from
the rim.
Brake pads must be kept parallel to rims, and the distance between
the brake pad and the rim must be no more than 2-3 mm. (B+C)
5