Checks And Maintenance - Nilox DOC E-BIKE X1 Manuel D'instructions

CHECKS AND MAINTENANCE

To prolong the life and efficiency of your DOC E-BIKE X1, certain operations need to be performed on a
regular basis:
Regularly check the tyre pressure.
•
• Check that the handlebar and saddle are always well secured.
Adjust the chain tension and lubricate it periodically.
•
• Before each use always check the reliability of the braking system.
Check that the wheel bolts are tightened.
•
• Check the condition of the tyres and replace them when worn.
Do not wash DOC E-BIKE X1 directly with jets of water, especially pressurised, since this could
•
damage the electrical components.
Clean dirty areas with a damp cloth and neutral detergent; then dry with care.
•
Treat the metal moving parts such as the chain with lubricating oil. TAKING CARE THAT NO
•
OIL DRIPS ONTO THE BRAKING PARTS. We recommend you have these operations performed
by qualified personnel.
Regularly check the tension of the chain, by releasing the quick-coupling clamp and holding
•
the wheel. Make sure that the wheel is perfectly in axis.
• Frequently check the reliability of the brakes.
CORRECT USE AND MAINTENANCE OF THE BATTERY
The following covers different methods of recharging and maintaining the battery, as well as any problems
that may arise. For the safety of the consumer and to prolong the life and improve performance of the
battery, please observe the following:
• The battery and the battery charger must be kept out of children's reach.
Only use the original battery charger; the use of a different battery charger could damage it
•
irreparably.
• Do not disassemble or modify the battery and/or its charger.
• Be extra careful when removing the battery from the bicycle, dropping it could damage it and
make it unusable.
• In the presence of unpleasant smells or excess temperatures during charging, stop the
procedure immediately.
DOC E-BIKE X1 cannot be used during the battery charging process.
•
• Make sure the battery and charger are connected before connecting to the electricity mains.
• Never let the battery charge level fall to zero, as this could reduce its life.
• Do not submit the battery to excessive charge cycles, if not needed.
If the bike is not used, recharge the battery at least every 2 months.
•
Do not charge the battery at high temperatures (above 40 C)
•
In winter, battery charging should be carried out at room temperature, if the bike was left in
•
the cold start the charging process after it has been brought back to room temperature.
• In the presence of unpleasant smells or excess temperatures during charging, stop the
procedure immediately.
Batteries contain hazardous substances. Do not open the battery and do not insert anything
•
inside it.
• If over-charged, lithium batteries may explode.
• Please keep the charging contacts clean and dry.
If the charging port is wet, do not charge.
•
• In order to avoid fire risks or electrical shock, when charging, only place the device in a room
with controlled temperature and humidity and without conductive agents of any kind.
• When charging, the device should be placed in a fully fireproof room (keep away from wood
floors, furniture, paper, sofas, rugs, flammable liquids, etc. .) with controlled temperature and
EN
8