Mounting The Anchor Nut And Bolt - LG UV42 Manuel D'installation

Mounting the anchor nut and bolt

- Prepare 4 suspension bolts. (Each bolts
length should be same.)
- Measure and mark the position for the
Suspension bolts and the piping hole.
- Drill the hole for anchor nut on the ceiling.
- Insert the nuts and washer onto the suspen-
sion bolts for locking the suspension bolts on
the ceiling.
- Mount the suspension bolts to the anchor-
nuts firmly.
- Secure the hangers onto the Suspension
bolts (adjust level roughly.) using nuts, wash-
ers and spring washers.
- Adjust a level with a level gauge on the direc-
tion of left-right, back-forth by adjusting sus-
pension bolts.
- Adjust a level on the direction of top-bottom
by adjusting supension bolts. Then the unit
will be declined to the bottomside so as to
drain well.
DIM
MODEL
VL 1655
VK 1255
VJ 855
Anchor nut
Ceiling
Nut
Washer
A
Suspension
bolts
Suspension bolt
A B
320
320
320
B
Suspension
bolts
Spring
washer
Nut
Hangen
Max.
Washer
12mm
THE INDOOR UNIT INSTALLATION
Hanging bolt
(W3/8 or M10)
Nut
(W3/8 or M10)
Spring washer
(M10)
- The following parts is option.
Hanging Bolt - W 3/8 or M10
Nut - W 3/8 or M10
Spring Washer - M10
Plate Washer - M10
! CAUTION
Tighten the nut and bolt to prevent unit
falling.
• Drill the piping hole on the wall slightly
tilted to the outdoor side using a Ø 70
hole-core drill.
Wall
Indoor
9
Flat washer for M10
(accessory)
Flat washer for M10
(accessory)
Nut
(W3/8 or M10)
Outdoor