Installation - Vacon 100 industrial Manuel D'installation

®
UK: VACON 100 drive supply switch

2. Installation

1
Remove the cover of
the drive.
2
Remove the two screws of
the drive supply switch
and tilt the switch to
the left.
3
Connect the motor
cable "M" (see Step 4).
Tighten the screws
according to the tighten-
ing torques given in
Table 1. Check also the
tightening of the factory-
installed drive supply
switch cable!
NOTE! Remember to use
cable grommets provided
with the drive, see the
®
VACON 100 installation
manual for detailed cable
installation instructions!
Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/
vacon • 5
M
uk