Chromatherapy Operation - Jacuzzi Fuzion 42x72 Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation
CHROMATHERAPY
• Press once to turn lights ON at
white level 2.
• Press again to cycle colors.
• Press again to stop at the current
color.
• Press again to restart the cycle.
If Chromatherapy fails to work:
Reset the GFCI.
Ensure the plug is fully in the outlet.
Ensure the connectors to the control panel and control box are fully engaged in receptacles.
Contact your electrician to ensure the proper wiring and power is being supplied to the GFCI.
Contact Jacuzzi Luxury Bath if the above does not resolve the issue.
DANGER:
Risk of electric shock!
Before you begin your installation, please read the following:
Observe all local and building codes.
Determine which tools will be used during the installation.
Additional bathtub drain parts and plumbing are commercially available at plumbing and hardware stores.
1. Install drain/overflow according to the manufacturer's instructions. Refer also to the Technical Specifications Manual.
Watertight installation of the drain is the installer's responsibility. Drain leakage is excluded from the Jacuzzi
Luxury Bath warranty of this product.
2. Install the faucet at this time (if applicable). It is recommended that the faucet be installed by a qualified plumber. See
special notes on freestanding section for faucetry.
Proper installation of the spout plumbing and compliance with local codes are the responsibility of the in-
staller. Jacuzzi Luxury Bath does not warrant connections of water supply fittings and piping, fill systems, or
drain/overflow systems. Nor is it responsible for damage to the bathtub which may occur during installation.
A non-flammable protective barrier must be placed between the soldering work and the bathtub unit to pre-
vent damage to the bathtub.

Chromatherapy Operation

INCREASE TOGGLE
• Press to increase light intensity.
• Press to turn ON lights at last
color used from OFF.
NOTE: Default lighting color is
white level 2.
Installation Procedures (All Models)
Turn off the power supply to the GFCI protected circuit.
www.jacuzzi.com
DECREASE TOGGLE
• Press to decrease light intensity
all the way down to off.
NOTE: Default lighting color is
white level 2.
English
Page 9

Publicité

Table des Matières
loading

Table des Matières