Operation - Jacuzzi Espree Série Instructions D'installation Et De Fonctionnement

all baths manufactured by Jacuzzi Whirlpool Bath
are designed for "fill and drain," which means the bath
should be drained after each use and filled with fresh
water by the next bather. This is a health precaution, as
these baths are not designed to hold water continuously
like pools or spas. If you want a unit designed to
continuously hold water, see your Jacuzzi Whirlpool
Bath dealer for the complete line of whirlpool spas
available.
once the bath is installed, remove any residue or
foreign materials left over from construction. Use
Fantastik or equivalent to remove stubborn stains,
®
paint, or tar. other dirt can be cleaned off with a mild
liquid detergent on a damp cloth. Scrape off plaster with
a wooden or plastic edge; do not use metal scrapers,
wire brushes or other metal tools, as they will
damage the bath's surface.
Water Level
Close the drain and fill the bath until water is at least
1" to 2" (25 mm to 51 mm) above the highest jet (see
water line indicated in the illustration). Do not turn on
the whirlpool system at any time if the jets are not
completely immersed in water. Running the whirlpool
system when there is insufficient water in the bath could
result in water spraying outside the bath area. Running
the whirlpool system without water will damage the
recirculating pump.
Copyright © 2007 by Jacuzzi Whirlpool Bath

OPERATION

FILL TO AT LEAST
1" - 2" ABOVE HIGHEST JET
TYPICAL BATH FITTINGS
MAGIC TOUCH
WHIRLPOOL
ON/OFF SWITCH
FULLY ADJUSTABLE JETS
SUCTION
COVER
Magic Touch Whirlpool Switch
®
the Magictouch whirlpool oN/oFF switch, conven-
®
iently located on the bath, allows you to turn the whirlpool
system oN and oFF while in the bath. Simply push
down on the switch button to turn oN the whirlpool
system. to turn the system oFF, push down on the
button again.
MAGIC TOUCH SWITCH
DEPRESS CENTER ON/OFF
1
®
AIR
CONTROL
KNOBS (2)
DRAIN/OVERFLOW
PUSH
ON/OFF
U961000K 06/07