Intended Use - Hilti C 6-22 Mode D'emploi Original

Charger operating status indi-
%
cator
Holes for wall-mounting
&

3.2 Intended use

The product described is a portable battery charger for Hilti Li-ion batteries
with a rated voltage of 21.6 volts. It is designed to be connected to power
outlets providing an AC (alternating current) voltage of 100 to 127 volts or
220 to 240 volts (depending on country-specific version).
The charger can be set on a flat surface or mounted on the wall.
A list of the Hilti Li-ion batteries approved for use with this product can
•
be found at the end of these operating instructions.
• Not all batteries are available in all markets.
3.3 Operating status indicator of the charger
Status
LED shows green.
LED doesn't light.
3.4 Status indicators of the Li-ion battery during charging
When a Hilti Nuron Li-ion battery is connected to a Hilti charger, the status
indicator of the battery shows the state of charge and also fault messages,
if applicable.
Status
One (1) LED slow-flashes green
One (1) LED shows green, one (1)
LED slow-flashes green
Two (2) LEDs show green, one (1)
LED slow-flashes green
Three (3) LEDs show green, one (1)
LED slow-flashes green
Four (4) LEDs show green
No LED showing
*2275225*
(
)
+
Meaning
Charger is ready for use.
Charger is not ready for use.
Meaning
The battery is being charged, state
of charge: ≤ 20 %
The battery is being charged, state
of charge: 21 % to 40 %
The battery is being charged, state
of charge: 41 % to 60 %
The battery is being charged, state
of charge: 61 % to 80 %
The battery is being charged, state
of charge: ≥ 80 %
The battery is fully charged, charg-
ing has ended.
2275225
Air exit
Air intake
Battery interface
English 5