Symbols On The Product; Product Information - Hilti C 6-22 Mode D'emploi Original

1.2.3 Symbols in illustrations
The following symbols are used in illustrations:
These numbers refer to the illustrations at the beginning of these
operating instructions.
The numbering reflects the sequence of operations shown in the
illustrations and may deviate from the steps described in the text.
Item reference numbers are used in the overview illustration and
refer to the numbers used in the key in the product overview sec-
tion.
These characters are intended to specifically draw your attention to
certain points when handling the product.
1.3 Product-dependent symbols

1.3.1 Symbols on the product

The following symbols can be used on the product:
The product supports near-field communication (NFC) technology
compatible with iOS and Android platforms.
Double insulated
For indoor use only
Direct current (DC)
Alternating current
If applied on the product, the product has been certified by this cer-
tification body for the US and Canadian markets according to the
applicable standards.

1.4 Product information

products are designed for professional users and only trained,
authorized personnel are permitted to operate, service and maintain the
products. This personnel must be specifically informed about the possible
hazards. The product and its ancillary equipment can present hazards if
used incorrectly by untrained personnel or if used not in accordance with
the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to inquire about the product.
Product information
Charger
Generation
Serial no.
2 English
C 6­22
01
2275225
*2275225*