Before Use; Switching The Appliance On; Operation - Hilti C 4/36 Mode D'emploi

5. Before use

5.1 Use the appliance only at a suitable
location.
Use the appliance only indoors.
The location at which the appliance is used should be
clean, dry and cool but protected from frost.
The appliance must be able to emit heat while in
operation. The ventilation slots must therefore remain
unobstructed.
Accordingly, remove the charger from the toolbox.
Do not operate the charger inside a closed container.
5.2 Battery use and care
NOTE
Battery performance drops at low temperatures.
Never use the battery until the cells become fully

6. Operation

6.1 Inserting and charging the battery 2 3
CAUTION
This appliance is designed for use with the specified
Hilti batteries. Charging other batteries is not permiss-
ible. A risk of personal injury or fire and irreparable
damage to the battery and charger may otherwise res-
ult. A caustic liquid may leak from defective batteries.
Avoid contact with this liquid.
NOTE
Before inserting the battery, check that the contacts
are clean and free from grease.
Depending on the type of Hilti battery, push or slide
the battery into the interface provided.
Check that the battery and charger interfaces match
(keyed fit).
Charging begins automatically after insertion of the
battery in the charger.
NOTE
- Charging does not begin automatically when the
yellow TPS battery indicator lamp blinks (only on C 4/
36 ACS TPS charger). Check that the battery interface
discharged. Change to the second battery in good
time. Recharge the battery immediately so that it is
ready for reuse.
Store the battery in a cool, dry place. Never store the
battery where it is exposed to the heat of the sun, on
a radiator, behind a motor vehicle windscreen or at a
window. Batteries that have reached the end of their
life must be disposed of safely and correctly to avoid
environmental pollution.

5.3 Switching the appliance on

Plug the supply cord into the power outlet.
NOTE
The green LED lights after the appliance has been
plugged in. If the green LED doesn't light or goes out
during operation, unplug the supply cord from the
power outlet and then plug it in again. If the green
LED still doesn't light after reconnecting it several
times, return the appliance to Hilti Service for repair.
matches the charger interface (both interfaces are
keyed to prevent insertion of incompatible types).
- The battery will suffer no damage even when left in
the charger for long periods. In this case, however, it
is necessary that the charger is operating (green LED
on the charger must be lit). After the battery has been
charged, it receives a regular trickle charge over a
period of 48 hours in order to ensure that full battery
capacity is maintained. The battery charge status LED
goes out after 48 hours, even although the battery is
fully charged. For safety reasons, it is recommended
that the battery is removed from the charger after
completion of the charging cycle.
6.2 Care of the Li ion battery
Avoid entrance of moisture.
Charge the battery fully before using it for the first
time.
In order to achieve maximum battery life, stop dis-
charging the battery as soon as a significant drop in
performance is noticed.
5