Transport And Storage - Hilti C 6-22 Mode D'emploi Original

4. Take a photo or draw a sketch so that you will be able to recall the
routing and conductor-to-terminal assignment of the supply cord.
5. Carefully depress one of the terminal clips with a flat screwdriver to
release the conductor. Disengage the conductor from the terminal clip.
Repeat this step for the second conductor and then remove the faulty
power cord.
6. Install the new supply cord.
screwdriver and insert the end of the conductor into the terminal clip.
Release the terminal clip and check that the conductor is secure in the
terminal clip. Repeat this step for the second conductor.
Materials
Supply cord C 6­22
2289588 (EU, 220­240V)
2289589 (US, 110­120V)
2289910 (GB, 220­240V)
2300624 (GB, 100­120V)
2289911 (KR, 220­240V)
2289912 (RU, 220­240V)
2289914 (JP, 100­120V)
2289915 (AUS 220­240V)
2289916 (TW, 100­120V)
2300625 (CH, 220­240V)
Select the supply cord of a type suitable for use with this charger
from this table or contact Hilti Service.
7. Seat the supply cord in the cable guide exactly as the original cable
was routed prior to replacement. Use the photo taken beforehand or the
sketch you drew as reference.
8. Flip the cover closed and re-install the securing screw.
9. Push the rubberized foot back into the cover.
10. Plug the supply cord into a power outlet and check that the charger is in
full working order.
▶ LED shows: Charger is in full working order.
▶ LED does not light up: Charger is not in full working order.
▶ Contact Hilti Service.
7

Transport and storage

Transport
▶ Make sure that the equipment is held securely throughout all transport
operations.
▶ After transporting, always check all visible parts and controls for signs of
damage and make sure that they all function correctly.
*2275225*
Depress one terminal clip with a flat
2275225 English 9