Kessel Pumpfix F Comfort Instructions D'installation, D'utilisation Et D'entretien page 39

Inspection/Maintenance Pumpfix F
Please note the safety instructions and accident prevention regulations
Maintenance work according to EN 12056-4 and DIN 1986 Part 3
Name of the building
Building
Street
Postcode, city
Contact
Type
Control unit
Pump type
Additional information
Fault message available
No. Test
1 Check control unit for possible fault messages
2 Manual function test on the control unit, close flap (using flap test hand symbol)
Make sure of inflow (clear water) ➞ wait to see if the pump starts working
No. Test
1 Documentation
1.1
Installation, operating and maintenance instructions available on site
1.2
Circuit diagram for control unit or control system available
2 Installation situation
2.1 Free access to the whole system guaranteed (inspection chamber, collecting tank, control unit)
2.2
Attached components such as e.g. pipes secured safely to cope with the load, and sound-proofed
3 Pumps / fittings / pipe / accessories
3.4
Aeration and vent pipe routed on a continual gradient via the roof to the outside (for wastewater with
sewage)
3.5
Cable conduit available; seal for cable gland in the inspection chamber
4 Control
4.1 Mains plug available and freely accessible / operable
4.2 Pre-fuse in the control cabinet accessible; marked; type / value
4.3
Electric conductor connections done properly (loose contact?)
5 Functional test
5.1
Fault message optically and acoustically correct; acknowledgement horn (acoustic signal)
5.2 Fault message potential-free correct; display to e.g. building management system (GLT);
acknowledgement / reset fault message
5.3 In as far as rechargeable battery / battery available for operation without mains voltage – fault message
correct
5.4 LED displays for control unit correct
2017/04
Maintenance
yes ❏ no ❏
1 ❏ 2 ❏
DN: da: Pumping height: m
yes ❏ no ❏
39 / 132
Done record
yes no
Done record
yes no
010-843