Setting Up The Monitor; Checking The Shipment - Philips SureSigns VS1 Manuel D'utilisation

This chapter describes how to install connectors and cables, power up the monitor, and recharge the battery.
Note— Philips recommends that the user has a clear understanding of the VS1 monitor, its intended use,
warnings, precautions, and the other information found in this manual before using this device for patient
monitoring.

Checking the Shipment

Examine the carton carefully for evidence of damage in transit. If you discover any damage, contact the
carrier immediately. Retain all packing material.
If you have to return the monitor, contact the Philips Response Center or your local Philips representative
for shipping instructions. The device should be cleaned and disinfected prior to shipping.
To pack the monitor, disconnect all cables. Pack the monitor in its original shipping carton. If this is
unavailable, use a suitable carton with appropriate packing material to protect the monitor during shipping.
Do not return sensors, patient cables, NIBP tubing and cuff, or the power cord.
Note—

Setting Up the Monitor

Caution—Use only the approved accessories for the VS1 monitor. See Chapter 12, Accessory List, for a
list of all approved accessories.
The following procedure explains how to connect all of the accessories on a fully configured model. If you
do not have all of the accessories, skip those steps that do not apply to your monitor. Refer to the following
diagram for connector locations.
Note— If you power up the monitor before connecting all of the accessories, an alarm sounds and one or
more error messages appear on the LCD screen. To avoid these alarms, connect all accessories before
powering up the monitor.
Setting Up the Monitor
2
2-1
Setting Up the Monitor