Engine Operation - Power Fist 8967028 Manuel D'utilisateur

8967028
2. Insert the screws in the holes and secure in place with the nuts.
GEAR CONTROL ASSEMBLY
1. Remove the previously assembled
articulated joint (Fig. 5A) on the washer
gear control (Fig. 5B) and nut (Fig.
5.C).
2. Insert the articulated joint (Fig. 5A) of
the gear control in the hole on the lever
(Fig. 5D) to connect it to the
transmission.
3. Secure the washer (Fig. 5B) and nut
(Fig. 5C).
BRUSH DIRECTIONAL CONTROL
ASSEMBLY
1. Remove the previously assembled
articulated joint (Fig. 6A) on the brush
directional control nut (Fig. 6B).
2. Insert the articulated joint (Fig. 6A) on
the brush directional control in the
lever hole (Fig. 6C) to connect it to the
drive.
3. Secure the nut (Fig. 6B).

ENGINE OPERATION

IMPORTANT! The motor is delivered without oil and fuel.
OIL
• Place the motor in a horizontal position.
• Remove the plug and fill with oil up to the edge (Fig. 7A).
FUEL
• Use lowest available octane unleaded fuel.
• When filling, place the machine in a horizontal position.
8
32 in. 3-in-1 Power Sweeper
For technical questions call 1-800-665-8685
V4.0