Table des Matières
Publicité
8951907
HOW TO ADD OIL
IMPORTANT! Read the Engine Oil section before adding oil to ensure that it
is suitable for the engine.
1.
Remove the oil filler cap (E) and place to one side.
2.
Place a funnel into the oil fill neck. The funnel opening should be wide
enough to prevent the oil from collecting in the funnel's cone.
3.
Pour oil into the funnel. Allow the oil to settle for one minute and recheck
the level. Repeat until the desired level is reached.
4.
Insert the oil filler cap and hand tighten.
5.
Wipe up any spilled oil. Dispose of oil soaked rags in a proper hazardous
waste container.
HOW TO DRAIN OIL
WARNING! Do not tip the engine while draining. This can cause fuel to leak
into the oil compartment, creating a potential fire hazard. If this is
unavoidable, drain the fuel from the engine before draining the oil.
1.
Remove the dipstick (D).
2.
Place an approved container below the oil drain plug (Fig. 5).
3.
Remove the oil drain plug and allow
oil to the drain into the approved
container.
4.
Install oil drain plug and tighten with
a wrench.
IMPORTANT! Used oil must be disposed
of properly. Do not pour it on the ground,
down a drain or throw it in the trash.
Take the oil to your local recycling
centre or a service station for reclamation.
CARBURETOR ADJUSTMENT
Never make adjustments to the carburetor. The carburetor was set at the factory
to operate efficiently under most conditions. Only a qualified service technician
should adjust the carburetor if it is required.
14
7-1/2 HP 212cc OHV Gas Engine
For technical questions call 1-800-665-8685
V 4.0
Fig. 5
Publicité
Table des Matières
