Care And Maintenance - Breg VPULSE Mode D'emploi

Cleaning your VPULSE
To clean your VPULSE, please follow these simple
steps:
1. Remove electrical cord.
2. Fill the empty water container to the MAX fill
line with fresh, room temperature water. DO
NOT USE ANY CLEANING SOLUTIONS IN THE
WATER RESERVOIR AS THESE SOLUTIONS
COULD DAMAGE THE WATER PUMP AND
THERAPY PADS.
3. Replace the handle and connect power.
Connect all pads and enable all functions.
4. Operate the system for 10 minutes.
5. Empty the water reservoir.
6. Repeat these actions periodically.
Please use only the following cleaning agents
when cleaning the outside of your VPULSE system:
warm water with mild detergent, Lysol
isopropyl alcohol, Cidex
Patients should not use cleaning or
decontamination methods different from those
recommended by the manufacturer without first
checking with the manufacturer that the proposed
methods will not damage the equipment.

Care and Maintenance

• DO NOT store the pad in its shipping bag. The
shipping bag may trap the moisture remaining
in the pad.
• Store the VPULSE unit in a safe, cool and dry
place when not in use.
• Ensure the water container is empty of water
and dry to avoid bacterial growth and
contamination.
• Wipe down the device with a soft, damp cloth.
DO NOT use abrasive cleaner. NEVER immerse
the unit into any liquid.
• Keep away from all solvents and harsh deter-
gents. Please refer to cleaning instructions
prior to cleaning your VPULSE.
• DO NOT attempt to repair the VPULSE. There
are no patient-serviceable parts. Repair of the
system by an unauthorized person may void the
product warranty.
• To store, disconnect the electrical cord, the
tubing set and the pad.
16 of 22
© , 70%
©
, or 10% bleach solution.
Storage
1
Remove water from the Thermal-Compression pad by
rolling the pad up while still connected and squeezing
the water back into the Container.
2
Remove the Ice Bottles from the unit. Separate the
bottles and pour the water out, air dry.
3
Dump the water out of the side Control Unit so that the
control buttons and other electrical components
stay dry. When empty, let the unit "air dry" completely.
For long term storage, please use the shipping materials
and container supplied with the VPULSE.
Lysol is a registered trademark of Reckitt Benckiser Inc.
®
Cidex is a registered trademark of Johnson & Johnson Corp.
®