Playing A Track - PIONEER DJ DDJ-SB2 Mode D'emploi

Playing a track

The following describes the procedure for outputting the channel 1
sound as an example.
1 Set the positions of the controls, etc., as shown
below.
Names of controls, etc.
1 TRIM control
2 EQ (HI, MID, and LOW) controls
3 FILTER control
4 Channel fader
5 MASTER LEVEL control
6 Crossfader
1
5
2
3
4
6
2 Press the [f] button to play the track.
3 Turn the [TRIM] control.
Adjust the [TRIM] control so that the channel level indicator's orange
indicator lights at peak level.
Position
Turned fully counterclockwise
12 o'clock position
12 o'clock position
Minimum (lowest) position
Turned fully counterclockwise
Center position
4 Move the channel fader to the maximum level.
5 Turn the [MASTER LEVEL] control to adjust the audio
level of the speakers.
Adjust the audio level output from the [MASTER OUT] terminals to an
appropriate level.
About the controls' setting values
The setting values of the controls, etc., below are controlled individually
for the respective decks in the Serato DJ Intro software.
! TRIM control
! EQ (HI, MID, LOW) controls
! FILTER control
! Channel fader
! TEMPO slider
If the values controlled by Serato DJ Intro when the decks are switched
differ from the positions of this unit's controls, faders, etc., the controls,
faders, etc., must be moved to the positions corresponding to the values
controlled by Serato DJ Intro before they will operate.
! The initial settings of decks 3 and 4 of Serato DJ Intro are the center
position for the [TRIM] control, [EQ (HI, MID, and LOW)] controls,
and [FILTER] control, ±0.0% for the [TEMPO] slider, and the mini-
mum (lowest) position for the channel fader.
9
En