Function) - Nissei WSK-1011 Instructions

V I E W I N G T H E S A V E D R E A D I N G S ( M E M O R Y F U N C T I O N )
Turn off the monitor once with "START/STOP" KEY when the results are
displayed after a measurement.
Refer to page 4 for memory function.
1 TOUCH MEMORY KEY.
Touch MEMORY KEY [1] to review readings saved in the memory bank [1]
and MEMORY KEY [2] to review those in the bank [2].
The average of the saved
readings are displayed.
Note: Average will not be displayed
unless there are two or more
readings saved.
2 TOUCH THE SAME MEMORY KEY AGAIN.
The latest reading saved in the selected bank
is displayed.
The display at the top shows memory
number, measurement date and time
alternately. The latest reading is displayed as
memory "No. 1".
The results are recalled from the latest to the oldest with operation of MEMORY
KEY.
The bigger memory number indicates the older number.
: Average
NUMBER OF
SAVED RESULTS
SWITCHING MEMORY BANKS
Touching MEMORY KEY [2] at display of reading in the bank [1] will switch
the display to reading in bank [2] and touching MEMORY KEY [1] again will
return to the display of result in the bank [1].
3 TURN OFF THE MONITOR.
Touch "START/STOP" KEY.
Even if you do not turn off the monitor, it displays the result for approximately 30
seconds and will turn off automatically.
DELETING SAVED READINGS
Deleting individual readings
Touch the memory key to display the latest set of readings. Then scroll
through the readings by repeatedly touching the memory key until you
reach the reading to be deleted. Then hold down memory key for 4
seconds until display flashes and continue to hold down key for about 4
seconds until reading is deleted and the display is cleared [
Deleting all the readings in a memory bank.
Select and display the average readings for the memory bank to be
deleted. Then delete by holding down the memory key continuously
until the display is cleared [
for the deletion of individual readings.
-12-
].
] as described in the sentence above