Memory Function - Nissei DS-1902 Instructions

To use "Personal Mode" efficiently, select your memory bank before starting a measurement; press
MEMORY SELECTOR to see which memory bank is selected, press MEMORY SELECTOR button to
change the memory bank number, then press START/STOP BUTTON once to turn off the monitor, and
then press START/STOP BUTTON to start a measurement. Select
Mode".

MEMORY FUNCTION

After a measurement, to add current reading to memory, press START/STOP
BUTTON once while measurement result is being displayed. Measured result is
stored in either M1 or M2. Make sure disired memory bank is selected before
turning the monitor off after a measurement. The result will not be saved
when is selected. Each of two memory banks, M1 and M2, can hold up
to 30 results and their average. When the number of measurements exceeds
30, the oldest data will be deleted to record new data.
1.
Press MEMORY BUTTON to see stored data.
Press START/STOP BUTTON once while measurement result is being displayed after a measurement.
The average of the stored results is displayed.
When there is only a single result, this reading will be displayed as the average.
The memory data is displayed for approximately 30 seconds. Approximately 30 seconds after MEMORY
BUTTON is released, the apparatus will turn off.
2.
Press MEMORY SELECTOR to change memory bank.
3.
Press MEMORY BUTTON to move to next data.
The memory data number 1 is the latest among the stored data.
Indication at the top alternates from memory data number to date and to time of measurement.
Every depression of the key switches among the memory data.
As MEMORY BUTTON is pressed, the memory data number increases; the bigger the number, the older
the result.
4.
Press START/STOP BUTTON to turn off the unit.
DELETING STORED DATA
1.
Display the data to be erased or the average to erase all the data in the memory.
2.
Press and hold down MEMORY BUTTON.
The displayed data starts flashing.
3.
Hold down the button until measurement result disappears.
- 17 -
MEASUREMENT PROCEDURES
"Personal Mode"
to avoid using the "Personal
30 30
fig.5