Precautions And Contraindications - Nissei WSK-1011 Instructions

Electric Rating : DC3V/2W
Memory : 2 banks, each stores 60 readings
Operating Condition : +10˚C to +40˚C, 15% to 85% RH (noncondensing)
Transportation/storage condition
: -20˚C to +60˚C, 10% to 95% RH (noncondensing)
Coverage wrist circumference
: 12.5 to 22.5 cm
Weight : Approx. 110 g (without batteries)
Size : Approx. 70 x 27 x 70 mm (W x D x H) , not including
the cuff
Protection class IP : IP 20: Protected against solid foreign particles with
a diameter of more than 12.5 mm, no protection
against water.
Protection against electric shock
: Internally powered equipment/Class II equipment,
Type BF applied part
Mode of operation : Continuous operation
Classification : Internally powered equipment
Expected service life : 5 years
Key to symbols
: Type BF applied part
P R E C A U T I O N S A N D C O N T R A I N D I C A T I O N S
Do not use this product without consultation with your doctor if you are
under dialysis therapy or on anticoagulants, antiplatelets or steroids. Use
of this instrument under such conditions could cause internal bleeding.
For specific information on your blood pressure, contact your physician.
Never make any judgment on your own regarding measurement results.
: Refer to instruction manual/booklet.
: Keep dry
: The used electrical and electronic products are
not household waste. Follow your national/local
recycling rules to dispose of them properly. In the
EU countries, please refer to waste management
symbol(s) marked on the package or the instrument.
*Accuracy is guaranteed with the measured values that are within the
measuring range.
• This device complies
sphygmomanometers Part 1: General requirements and EN1060-
3:1997+A2:2009 Non-invasive sphygmomanometers Part 3: Supplementary
requirements for electro-mechanical blood pressure measuring system.
• The measurement accuracy of the product has been proven according to ISO
81060-2 protocol. In the clinical study, K5 was used for the determination of
diastolic pressure values at all auscultatory measurements.
• This product is intended for use in the environment with one atmospheric
pressure.
Specifications are subject to change without notice due to improvements in
performance.
Do not use this product along with implantable and wearable medical electrical
equipment such as pacemaker, defibrillator, or electrocardiographic monitor.
This product is not also intended to be used with HF surgical equipment.
Do not use this product in an explosive environment such as near
flammable anesthetics or inside oxygen chamber.
-5-
with EN1060-1:1995+A2:2009 Non-invasive