Installing The Heat Shield - Gaggenau VI 422 611 Mode D'emploi

en-us
Installation Procedure
Note: Follow the installation instructions provided for the
control knobs.
1.
Depending on the distance between the control
knobs, it may be necessary to break off the retaining
plate at the perforation. Hold the retaining plate in
place against the back of the control panel or the
bottom of the countertop, or secure it with the
enclosed screws.
2.
When installing a single control knob or when the
retaining plate has been broken at the perforation, use
2 screws to hold each individual retaining plate in
place to prevent it from rotating (C).
For stone countertops, use temperature-resistant two-
component adhesive (for metal to stone) to adhere the
retaining plate.
3.
Remove the protective film on the back of the
illuminated ring (A).
4.
Insert the control knob into the drilled hole (B) and
screw the nut on the back with the enclosed
installation aid (D).
5.
Connect all of the control knobs with the enclosed
shorter cables. The plugs must snap into the sockets
(E).
Note: The two cable connectors on the control knob
are identical.
6.
Connect the longer cable to the control cable for
connection to the appliance. The plug must snap into
the socket (F).
Note: The appliance can be connected to any control
knob.
7.
After installing, check that all plug connections fit
correctly.
8.
After installing all the cables, secure them to the
retaining plate by bending the tab down (E).
10

Installing the heat shield

9
CAUTION
Sharp edges. Use protective gloves when installing
the plate.
For safety reasons, the heat shield must be properly
installed. This prevents components from overheating as
a result of the recirculation of hot air from the cooktop.
The heat shield is the same width as the cooktop. For
shipping, it is screwed to the burner box.
After unpacking the cooktop, unscrew the heat shield.
The heat shield will be able to rotate freely, as shown in
the illustration.