Brewing A Jug Of Coffee - Philips Senseo Sarista HD8030 Mode D'emploi

EnglisH
10
M A X
4203_000_7242_2_DFU-Luxury_A5_v1.indd 10
- Press the 1-cup button to brew 1 cup of coffee.
The coffeemaker grinds the required amount of coffee beans for one
,
cup and then brews one cup of coffee.
The activity light flashes once when the beans are ground.
,
- Press the 2-cup button to brew 2 cups of coffee.
, The coffeemaker grinds the required amount of coffee beans for
one cup and then brews coffee filling both cups half. Then the
coffeemaker again grinds the coffee beans for one cup and brews the
coffee filling both cups fully.
The activity light flashes once when the beans for the first half are
,
ground and twice when the beans for the second half are ground.
Note: If the coffeemaker stops during brewing, the water tank or bean-funnel
may be empty or the coffee grounds container may be full. Fill the water tank,
replace the bean-funnel or empty the coffee grounds container and press
the 2-cup button again to complete the brewing cycle. Make sure the coffee
grounds container is taken out of the appliance for 3 seconds until the bean-
funnel empty light stops flashing, then place it back.
6 When the 'bean-funnel empty' light goes on, the bean-funnel is empty.
7 To replace the empty bean-funnel with a full one, turn the bean-
funnel anticlockwise (1) and remove it (2). Then perform step 1 to
place a new full bean-funnel on the coffeemaker.
Note: You can also remove a Douwe Egberts SENSEO
that is not yet empty and replace it with another one if you want to switch to
a different coffee blend. Because the bean-funnel is re-closed, you can store the
used bean-funnel for later use.
Never remove the bean-funnel when the coffeemaker is brewing coffee.

Brewing a jug of coffee

When you press the jug button, the coffeemaker brews six cups of coffee
into the jug.
Note: Always clean the jug with warm water and some washing-up liquid before
first use. If you have not used the jug for a while, rinse it with warm water to
remove any odour.
Check if the water tank is filled to the MAX indication. Fill the water
1
tank with water, if necessary (see chapter 'Preparing for use').
Note: If you do not fill the water tank to the MAX indication, the 'water tank
empty' light may go on and the coffeemaker may stop during brewing. Fill the
water tank and press the jug button to continue brewing coffee.
SARISTA bean-funnel
®
1/9/13 1:37 PM