Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
Plastic hose
Leakage control at the connection point
•
Make sure that all knobs on the pro-
duct are turned off. Make sure that the
gas supply is open. Prepare soapy
foam and apply it onto the connection
point of the hose for gas leakage cont-
rol.
•
Soapy part will froth if there is a gas
leakage. In this case, inspect the gas
connection once again.
Never use a match or lighter to make
the gas leakage control.
If there is a built-in oven installed under
the hob;
•
Gas hose must be routed in a way that
it will not touch the oven, sharp edges
or corners beneath the hob, or will not
be kinked or twisted.
If you will make the gas connection
from left hand side when viewed from
your position, fix the hose with clamps.
1
Bottom view
2
Hose tip
3
Hose
4
Clamp
5
Oven
Installing the product
1. Remove burners, burner caps and grills
on the hob from the product.
2. Turning the hob upside down, place it
on a flat surface.
3. In order to avoid the foreign substances
and liquids penetrate between the hob
and the counter, please apply the putty
supplied in the package on the contours
44/EN
of the lower housing of the hob but ma-
ke sure that the putty does not overlap.
4. Fill the corners by forming bends at the
corners as illustrated in the figure. Form
as much bend as required to fill the gap
in the corners.
Make sure that the skirting secti-
ons on the lower housing of the
hob are filled with putty.
5. Turning the hob again, align and place it
on the counter.
6. You can secure your hob to the counter
by using the clamp and the screws
supplied.
1
Hob
2
Putty
3
Installation clamp
4
Counter
Thickness of the counter must be at least
40 mm.
When installing the hob onto a cabi-
net, a shelf must be installed in order
to separate the cabinet from the hob
as illustrated in the above figure. This
is not required when installing onto a
built-under oven.
For example, if it is possible to touch the
bottom of the product since it is installed
onto a drawer, this section must be covered
with a wooden plate.
*
min. 25 mm
.
Publicité
Table des Matières
