Beko HIML 95225 SXE Mode D'emploi page 43

•
Connection must comply with national
regulations.
•
The mains supply data must corres-
pond to the data specified on the type
label of the product. Type label is at the
rear housing of the product.
•
Power cable of your product must
comply with the values in "Technical
specifications" table.
DANGER:
Before starting any work on the
electrical installation, disconnect the
product from the mains supply.
There is the risk of electric shock!
Power cable plug must be within
easy reach after installation (do not
route it above the hob).
Plug the power cable into the socket.
Gas connection
DANGER:
Product can be connected to gas
supply system only by an authorised
and qualified person or technician
with licence.
Risk of explosion or toxication due to
unprofessional repairs!
Manufacturer shall not be held res-
ponsible for damages arising from
procedures carried out by unauthori-
sed or unlicensed persons.
DANGER:
Before starting any work on the gas
installation, disconnect the gas
supply.
There is the risk of explosion!
•
Gas adjustment conditions and values
are stated on labels (or ion type label).
The gas type of your product is sta-
ted on type label placed bottom of
hob.
Connecting the gas hose For NG
•
Natural gas installation must be prepa-
red before installing the product.
•
There must be a pipe (Piping advised
to be buyed from a licensed installer),
must comply with local gas standard, at
the outlet of the installation for the na-
tural gas connection of your product
and the tip of this pipe must be closed
with a blind plug. Service Representa-
tive will remove the blind plug during
connection and connect your product
by means of a straight connection de-
vice (coupling).
•
Make sure that the natural gas valve is
readily accessible.
•
If you need to use your product later
with a different type of gas, you must
consult the Authorised Service Agent
for the related conversion procedure.
Connecting the gas hose For LPG
•
Have your product connected in a way
that it will be close to the gas connec-
tion and not gas leakage will exist.
•
Plastic hose to be used must not be
longer than 125 cm.
•
Install the clamp to the hose. Soak one
end of the hose (15 mm inner diameter)
into boiling water for one minute to sof-
ten it.
•
Than, slip the softened end of the hose
completely onto the sharp hose tip of
your product. Finally, tighten the clamp
completely with a screwdriver.
•
Repeat the same procedure for the
other end of the hose and complete the
gas cylinder connection.
•
Never forget to make the gas leakage
control.
DANGER:
Risk of explosion and suffocation!
Do not keep LPG cylinders in home.
•
If you need to use your product later
with a different type of gas, you must
consult the Authorised Service Agent
for the related conversion procedure.
1 LPG hose tip
43/EN