Beko HIML 95225 SXE Mode D'emploi page 52

7 Troubleshooting
Clanging is heard while the product is heating and cooling.
•
When the metal parts are heated, they may expand and make noise. >>>
not a failure.
There is no ignition spark.
•
Power is cut. >>>
The product is continuously sparking.
•
The effluent fluids may have penetrated into the ignition mechanism under the control
Unplug the product and wait for it to cool.
knobs. >>>
There is no gas.
•
Main gas valve is shut off. >>>
•
The pipe has leaned. >>>
Burners are not burning properly or at all.
•
Burners are dirty. >>>
•
Burners are wet. >>>
•
Burner cap is not securely positioned. >>>
•
Main gas valve is shut off. >>>
•
Gas cylinder is empty (when using LPG). >>>
•
The burner knob/button has not been hold pressed enough during ignition. >>>
nite the burner by pressing and holding for at least 3-5 seconds.
Consult the call centre if you can not remedy the trouble although you have implemented the
instructions in this section. Never attempt to repair a defective product by yourself.
52/EN
Check the fuses in the fuse box.
Turn on the gas valve.
Install the gas pipe properly.
Clean the burner components.
Dry the burner parts.
Turn on the gas valve.
Position the burner cap correctly.
Replace the gas cylinder.
This is
Ig-