shark RSR2 Mode D'emploi page 3

2. with the chin strap properly faste-
ned, be sure that the helmet cannot
be moved excessively from side to
side or up and down. You should feel
the skin of your head and face being
pulled as you move the helmet. If not,
the helmet is too big for you; select a
smaller size.
see figure
3. Grasp the back of the helmet at the
base and attempt to pull the helmet
off your head. next, push the helmet
upwards from beneath the chin
guard. You should push and pull with
relatively significant force. If the
helmet starts to come off, the helmet
is too big for you; select a smaller
size.
4. Bend your head forward as far as
possible. The chin guard must not
touch your chest.
5. Bend your head backwards as far
as possible. The helmet shell must
not touch your back.
RSR2 DOT-V03.indd 3
B.
see figure
see figure
C
never wrap your hair inside the hel-
met, or place anything in or on your
hair inside the helmet. never insert
padding to modify the position of the
helmet on the head.
If you have any questions about
properly sizing your helmet, see your
retailer for assistance.
each of these tests must be repeated
throughout the life of the helmet, as
the comfort padding may wear or
change over time. If, during the life
of your helmet, your helmet does
not maintain the correct fit, you must
replace the helmet.
never lend your helmet to others
without insuring a proper fit in accor-
dance with these instructions.
WARNING: If you cannot obtain
a proper fit in accordance with
these instructions, DO NOT USE THE
C.
HELMET. Select a different helmet
size or model.
D.
D
3
11/04/06 18:51:44