FYTTER runner RU-6X Mode D'emploi page 39

A) Incline motor wire not well
connected.
E04
B) Incline motor broken.
C) Pcb broken.
A) Over-loaded.
B) Driving position hinder.
E05
C) Motor short circuit
D) Pcb burnt.
A) Pcb torque too big.
E10 B) Motor short circuit.
C) Driving position hinder.
Re-connect incline motor wire.
Change new incline motor.
Change new pcb.
Turn off and re-start machine.
Adjust driving position, or add oil.
Change new motor.
Change new pcb.
Adjust torque to right position.
Change new motor.
Adjust driving position, or add oil.
FYTTER |WWW.FYTTER.COM PAG- 38