Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
Details about the MCM10 module
2
Details about the MCM10 module
2.1
Declaration of conformity
The design and operation of this product
conform to the U.S. and Canadian Directives.
Its conformity is demonstrated by the CSA
designation.
The Declaration of conformity can be
claimed. See the address at the back of this
manual.
2.2
Information regarding the
documentation
Hand all enclosed documents over to the user.
We reserve the right to make technical modifications!
2.3
Proper use
The MCM10 modules are designed to control cascade
systems. A cascade system is a heating system where
several smaller heating appliances are connected in
parallel to achieve a higher output (
The MCM10 modules are only suitable for controlling
heating appliances with Logamatic EMS BUS.
For floor-standing heaters, the MCM10 module is only
suitable for the activation of gas heaters with modulating
burners without operating conditions.
4
2.4
Fig. 12, page 19).
Fig. 1
1
2
3
4
5
6
B Check that the delivery is complete.
2.5
Here is a list with typical accessories. In order to get a
complete overview of all available accessories, please
contact the manufacturer.
• Outdoor temperature sensor FA for connection to
• RC35: Outdoor reset heating system controls with
• WM10: Low loss header module for EMS.
• MM10: Mixer module for EMS.
• AM10: Outdoor reset controller with thermostat
Scope of delivery
5
Scope of delivery
MCM10
Duct connection box
Sensor well
Supply temperature sensor FV
Package with:
- 3 screws and 3 wall-plugs
- 4 strain relief clips and 8 screws
Installation and operating instructions
Accessories
terminal F (only for system variant 1).
plaintext display for controlling a heating system with
mixed or unmixed heating zones.
connection.
1
2
4
3
6
6 720 616 690-02.1TD
MCM10
Publicité
Chapitres
Table des Matières
