Program The Remote Transmitter - SportDOG 1275 Guide De Démarrage Rapide

STEP::02
TURNING THE SPORTTRAINER
Once charged, the Remote Transmitter is on. Press any button to send signals.
TO TURN THE COLLAR RECEIVER ON:
Press and release the On/Off Button. The Receiver Indicator Light will come on solid green and the Collar Receiver
will beep 1 to 3 times indicating which static stimulation range is set. The default is 2 (medium).
TO TURN THE COLLAR RECEIVER OFF:
Press and release the On/Off Button. The Receiver Indicator Light will come on solid red and the Collar Receiver
will beep for 2 seconds. To extend the battery life between charging cycles, turn off the Collar Receiver when it is
not in use.
STEP::03

PROGRAM THE REMOTE TRANSMITTER

The SportTrainer SD-1275E Remote Trainer has 12 operational modes to best match your style of training. See
®
STEP 05 of your Operating Guide for complete descriptions of the available modes.
NOTE: The Remote Transmitter is factory set to mode 1.
TO CHANGE THE MODE:
1. Refer to the following table to review the available modes.
2. Using the Intensity Buttons +/-, set the display to 1.
3. Turn the Remote Transmitter over and remove the belt clip (if attached).
4. Using a pen or the tine of a buckle, depress and release the Mode Button. Select the desired mode using the
Intensity Buttons +/-. After 5 seconds, your selected mode will flash to indicate that it has been set. Your
remote transmitter will now return to the same Intensity level and dog to which it was previously set.
For multi-dog dog operation, refer to STEP 07 in the Operating Guide.
SD-1275E COMPONENTS ON AND OFF
®
SPORTDOG.COM
5