Inline Fuse; Frequently Asked Questions - MINN KOTA MK106D Manuel De L'utilisateur

Masquer les pouces Voir aussi pour MK106D:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GENERAL MAINTENANCE

INLINE FUSE

The output cord has an inline fuse on the RED end. The fuse serves as protection from surges and short circuits caused
by a damaged charger output cable. If a fuse blows, replace it with a 30 amp ATC 32V automotive fuse. Improper battery
connections will normally not cause a fuse to blow since this is handled by the internal circuitry of the charger.

FREQUENTLY ASKED QUESTIONS

1.
Can I charge two batteries on one charger bank?
• Yes, but it is not recommended. It takes double the amount of time to charge two batteries and could result in an error being
displayed if the batteries take too long to charge.
2. Do I need to disconnect the series or parallel battery connection(s) when using Minn Kota chargers?
• No, the battery jumper wire(s) can remain in place for both types of wiring.
3. How warm do Minn Kota battery chargers get?
• The Minn Kota battery chargers can reach 150° F. They may get warm in an enclosed area. The maximum recommended
room temperature for charging batteries is 122° F. If the charger seems to get "hot," try opening a hatch to help cool the
charger. When the charger is hot, the output current will drop to protect the charger and the battery.
4. What size fuses are used on Minn Kota battery chargers?
• Chargers with a yellow fuse holder use a 30 amp AGX 32V automotive fuse. An AGC can be used but may not fit as well as
the AGX. Chargers with a red fuse holder use a 30 amp ATC 32V automotive fuse.
5. What Batteries can be charged by a Minn Kota charger?
• Minn Kota Chargers can charge 12 volt 6 cell lead-acid batteries. Minn Kota D Series Chargers and Minn Kota
Portable Chargers work well with LEAD-ACID: FLOODED/WET CELL, MAINTENANCE FREE, and AGM/STARVED
ELECTROLYTE. Minn Kota PC series Chargers have optimized charging for LEAD-ACID: FLOODED/WET CELL,
MAINTENANCE FREE, GEL and AGM/STARVED ELECTROLYTE battery types. You should verify with your Battery's
Manufacturer the maximum Amp input for your Battery. The Amp Hour or AH rating for your battery should be in the range
indicated below for the per bank amp output of the battery charger selected.
Model
MK106D
MK210D
MK220D
MK315D
MK330D
MK330DS
MK440D
20 | minnkotamotors.com
Battery Charger Output Per Bank
6 AMPS
5 AMPS
10 AMPS
5 AMPS
10 AMPS
10 AMPS
10 AMPS
Battery Amp Hour Rating
24-125 AH
20-125 AH
40-125 AH
20-125 AH
40-125 AH
40-125 AH
40-125 AH
©2017 Johnson Outdoors Marine Electronics, Inc.

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Mk210dMk220dMk315dMk330dMk440d

Table des Matières