Maintenance Instructions; General Maintenance; Inline Fuse; Frequently Asked Questions - MINN KOTA MK-105PD Manuel De L'utilisateur

MAINTENANCE INSTRUCTIONS

GENERAL MAINTENANCE

• Check battery charger for dirt, oil, battery corrosion, etc. Use a water and baking soda solution for cleaning corrosion. Wipe
clean using a dry cloth.
• Check clips for dirt, oil, and battery corrosion; then disconnect from battery posts and clean as necessary with water and
baking soda solution and dry with a clean cloth.
• When the charger is not in use, coil the power cord and output cord to prevent damage.
• When storing the battery charger, store in a clean dry area.
• If power cord or plug becomes damaged, you may contact the Minn Kota Service Repair Department for service repair
information. Otherwise, dispose of the battery charger in compliance with local law. Damaged cords and plugs can cause
electric shock or electrocution.
Damaged cords and plugs can cause electric shock or electrocution.
Model Part No.
MK105PD 1831050
MK110PD 1830110
Model Part No.
MK105PD 1831050
MK110PD 1830110

INLINE FUSE

The output cord has an inline fuse on the RED end. The fuse serves as protection from surges and short circuits caused
by a damaged charger output cable. If a fuse blows, replace it with a 30 amp ATC 32V automotive fuse. Improper battery
connections will normally not cause a fuse to blow since this is handled by the internal circuitry of the charger.

FREQUENTLY ASKED QUESTIONS

1. Can I charge two batteries on one charger bank?
• Yes, but it is not recommended. It takes double the amount of time to charge two batteries and could result in an error being
displayed if the batteries take too long to charge.
2. Do I need to disconnect the series or parallel battery connection(s) when using Minn Kota chargers?
• No, the battery jumper wire(s) can remain in place for both types of wiring.
14 | minnkotamotors.com
DANGER
MECHANICAL SPECIFICATIONS
Banks Input Cable
1 18AWG - 6"
1 18AWG - 6"
ELECTRICAL SPECIFICATIONS
System Output per Bank
Volts (amps)
12 5
12 10
Output Cable Size L x W x H
16AWG - 6' 5" x 7" x 6-1/2"
16AWG - 6' 7" x 9" x 7-3/4"
Total Output
(amps) (120VAC, 60Hz)
5
10
Weight (lbs)
3.5
6.5
Input Current Input Power
(120VAC, 60Hz)
0.8A 90W
1.8A 180W
©2017 Johnson Outdoors Marine Electronics, Inc.