Speed And Temperature Of The Rollers Programming; Mistral 2000 Hr; The Start-Up Kit Of Films; Automatic Stand-By Of The Mistral 2000 Hr - kala 1600 HR Manuel Utilisateur

1-4

Mistral 2000 HR

The Mistral 2000 HR is delivered
positioning on the support unit.
Hold the machine by the carrying
handles in order to move it.
Break the Mistral 2000 HR from the
palette. Hold the machine by the car-
rying handles, move it in order to put a
side on the ground, and then the sec-
ond side.
1-5 The start-up kit
In the packing, you will find a comple-
te start-up kit containing :
2 S
PEED AND TEMPERATURE OF THE ROLLERS PROGRAMMING
The programs M1, M2, M3 and M4 can be selected by the operator.
To activate a program, press
corresponding to the required program comes on.
2-1

Automatic stand-by of the Mistral 2000 HR

The light
machine has been automatically swit-
ched to stand-by after 30 mn of non-
use. The stand-by temperature can be
2-2

Speed programming

Mistral 1600 HR
To set-up the speed, the light (e) must
be off. if not, press
Adjust the speed of the rollers by pres-
sing the
control panel.
The last value entered automatically
replaces the previous stored value.
*Press successively
EDNord - Istedgade 37A - 9000 Aalborg - telefon 9633 3500
MODE
(k) indicates that the
(g).
and keys (j) of the
(a) until the light corresponds to
1
- One roller of assembly film
(double-sided).
- Two rollers of cold adhesive film.
or (a) buttons successively until the light
set in the range 20-60°C. The rollers
diverge automatically.
*Press
the roller heating.
c
FORWARD
d
e
f
STOP
g
h
REVERSE
(n) , to stand-by manually the roller heating.
39
(n) to stand-by manually
PRESSURE
1 2 3 4 5
1 2 3 4 5 6 7 8 910
SPEED
POWER
i
j
k