Remote Control - Dimplex DF3033ST Manuel Du Propriétaire

Operation
support. Please have your
model and serial number
ready when calling.

Remote Control

The remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with 243 in-
dependent frequencies to prevent
interference with other units.
Battery Installation
1. Depress tab on the battery
cover on the back of the
remote control and remove
battery cover (Figure 5).
2. Install two (2) AAA batter-
ies into the remote control
(included).
3. Ensure child lock is in the "un-
locked" position (Figure 5).
Figure 5
Batteries
Child Lock
4. Replace the battery cover.
!
NOTE: When the "BAT" sym-
bol is present on the remote
control it is recommended to
replace the batteries promptly,
to maintain full functionality
of the remote/fireplace. The
remote control has a battery
backup time of only several
hours.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.
Initializing/Reprogramming
the Remote Control
1. Plug cord into 120 Volt wall
outlet.
2. Ensure the On/Off Switch
located in the switch box on
the fireplace in the upper right
hand corner is in the
position (Figure 4A).
3. Set the 3 Position Manual
Control (Figure 4B) to the Re-
mote position (left position).
4. Press and hold the Initializa-
tion Button on the unit (Figure
4C).
5. While holding the Initializa-
tion Button, press the Flame/
ON
11