Operation; Manual Control; Remote Control - Dimplex Revillusion 25 Manuel D'utilisation

Operation

Manual Control

The manual controls for the Revillusion
are located on the right-front leg of the
log grate.
Power
Press to turn the flame effect on
and activate the previous heat
setting (Off, Low, or High). Press
again to put the unit in standby
mode.
Heat
• Heat On
Press to set the heat to Low
(indicated by 1 short beep).
Press again to set the heat
to High (indicated by 2 short
beeps).
• Heat Off
Press to turn heat Off (indicated
by 1 long beep).
NOTE: After the heater is
!
switched off, the fan will continue on
for 60 seconds before turning off.
The log LEDs remain On when the
heater is ON and the flame effect is
Off.
Color Themes
Press multiple times to change
the LED lights from: flame base
yellow, flame base blue, flame
base yellow with yellow 360
LEDs, flame base blue with 360
LEDs. (Feature is active only
when the flame effect is On.)
Brightness
Press multiple times to toggle
the log set LEDs through its four
brightness settings.

Remote Control

The fireplace is supplied with a multi-
function remote control.
The remote control has a range of
approximately 30ft (9m). To operate
correctly, the remote control must be
pointed toward the front of the unit.
Power
Press to activate the current
standby state (On/Off).
• Standby State On
Press to turn everything Off.
Press again to active the
previous flame effect state.
• Standby State Off
Press to activate the previous
flame effect state.
9