Dimplex DF3033ST Manuel Du Propriétaire page 12

Operation
Heat On/Off
remote control.
6. Release the Initialization But-
ton on the unit.
7. Press the Flame/Heat On/Off
button
Heat function on.
Frequency Interference
If the fireplace does not respond
properly to the remote control,
the remote operating frequency
may have to be reset. The remote
control can send another fre-
quency code to the remote control
receiver to eliminate interference.
1. Simultaneously press the
"Temperature Down" but-
ton and the "Flame Speed
Down" button on the remote
control (Figure 6).
2. "COD" will appear in place of
the sleep timer digits.
3. Release the "Temperature
Down" button and the "Flame
Speed Down" button.
4. Press the Initialization Button
on the unit (Figure 4C).
5. Press the Flame/Heat On/
Off Button
remote.
Your remote will now have a dif-
12
button on the
to turn the Flame/
button on the
ferent frequency communicating
with the fireplace.
Remote Control Functions
(All letter references are to Figure 6)
B. Set Temperature
Press F button
place on.
Press H to raise thermostat.
Press G to lower thermostat.
Press both H and G to change
°F to °C.
C. Dimmer
Press the F button
the Flame/Heat on.
Repeatedly press the J or I
button to decrease or increase
the brightness of the upper
lights.
D. Flame Speed
Press the F button
the Flame/Heat on.
Press the L button to increase
the speed of the flame.
Press the K to decrease the
speed of the flame.
E. Sleep Timer
The Sleep Timer automatically
shuts off the fireplace after a
preset time (from 30 minutes
to turn fire-
to turn
to turn
www.dimplex.com