TOPRO TROJA 2G Manuel D'utilisation page 18

1.
2.
S
2.
1.
3.
2.
3.
Comfort Wheel Grip Comfort Wheel Sof
S
16 16
E. Brakes
Stopping and parking
The brake handle can be used in two different ways
- as a driving brake or as a parking brake.
Driving brake (1.):
when pushing the TOPRO Troja 2G. To apply the driving brake, simply
pull the brake handles up. The brakes are applied instantly. Release
the handles, and the TOPRO Troja 2G is once again ready to move
forward. To prevent damaging the wheels, the brakes should not be
applied continuously while walking.
Parking brake (2.):
is parked for a short or long period, i.e. when you want to take a break
from walking and sit on the seat. It is vital to apply the parking brake
in this situation! To apply the parking brake, push the brake handles
down towards the frame. To release, simply pull them back up.
F. Adjusting / checking and maintaining the brakes
Loosen the nut beside the brake (1.). Tighten the brake wire with the
adjustment screw (2.). Adjust the brake block (3.) as close as possible
to the wheel, and turn the wheel around to check that the brake block
is not touching the wheel.
Make sure the brakes are not adjusted too tight and pressing into the
rubber when the parking brake is on. The brake blocks and springs
should be cleaned regularly to guarantee their optimal operation.
1.
G. Replaceable wheels „TOPRO Quick"
Suitable wheels for any surface
If you want to remove the wheels for transportation or replacement,
follow these instructions:
Remove:
(1.), and slide the wheel off the axle while still pushing the button down.
Attach:
Slide the wheel unto the axle while keeping pressure on the button (2.).
Push the wheel as far as possible inward on the axle and release the
button to make the wheel snap onto the axle. The wheel is securely
fastened when the axle is completely visible in the middle of the hub
and you cannot see any of the grey marks (3.). The grey button should
now have popped back up from the hub. Gently rock the rollator from
side to side to ensure that the wheel is securely fastened to the axle.
After the new wheel has been applied to the rollator, make sure that
the brake lever is reattached and the brakes are functioning pro-
perly. Readjust them if necessary (p.16, point F).
Choose the appropriate wheels for your surroundings:
Comfort Wheel Grip
t
Comfort Wheel Soft
C
The driving brake is used to reduce your speed
The parking brake is used when TOPRO Troja 2G
Loosen the brake lever. Push down the grey button on the hub
Loosen the brake lever. Push down the grey button on the hub (1.).
(standard): Manoeuvrable, with a good grip on
smooth surfaces like flooring and
even road (made of TPE)
(optional): Comfortable and secure on unsurfaced
road, cobblestones etc., available as an
accessory, see p. 20 (made of PUR).