Recommendations For Use - jbc AD 2950 Mode D'emploi Rapide

Structure of AD 2950 soldering station
The AD 2950 has 3 basic modules giving you full
flexibility for choosing what you need for the work
in hand, the modules being supplied separately.
Control unit
- AD 2950 230V
- AD 2950 120V
- AD 2950 100V
Handpieces
- 2210
Power: 20W. For high precision work, SMD, etc.
- 2245
Power: 50W. For general soldering work.
One version of 2245 soldering iron handpiece
covered with a heat insulator is available.
- 2245 comfort handpiece
Other handpieces:
- 2245 comfort handpiece 3 mt
- 2245 handpiece with set screw Ref. 2245130
- 2245 soft grip handpiece
- 2245 hard grip handpiece
Cartridges
- 2210 cartridge range (for the 2210 handpiece)
- 2245 cartridge range (for the 2245 handpiece)
The 2210 and 2245 handpieces and cartridges
comply with the MIL-SPEC-2000 referring to the
potential difference between the soldering tip and
ground connection, must be less than 2 mV.
For a station to work properly, a control unit, a
handpiece and one cartridge are needed.
AD 2950 control unit
The station is supplied with:
- Control unit which incorporates a stand with
sponge and cartridge extractor.
- Connection cable to mains.
- Instructions manual.
- Transport packaging.
Technical specifications
- Temperature selection from 90 to 450°C or
190 to 840ºF (±5%).
- Power: 75W.
- Safety transformer, mains separator and
double isolation, with integrated temperature
Ref. 2950200 protection fuse.
Ref. 2950100
- AD 2950 230V control unit
Ref. 2950110
Input: 230V 50Hz. Output: 24V
- AD 2950 120V control unit
Input: 120V 60Hz. Output: 24V
Ref. 2210000
- AD 2950 100V control unit
Input: 100V 60Hz. Output: 24V
Ref. 2245000
- Total weight of unit: 2.6 Kgs (6,5lbs).
- ESD protected housing.
Typical surface resistance: 10
square.
Ref. 2245110
- Complies with CE standards on electrical
safety, electromagnetic compatibility and
Ref. 2245120
antistatic protection.
- RoHS compliant.
Ref. 2245140
- Equipotential connector and the tool tip are
Ref. 2245150
connected to station mains ground supply for
ESD protection.

RECOMMENDATIONS FOR USE

For soldering
-
-
Safety measures
-
2
This product should not be thrown in the
garbage.
Preferably select a temperature below
350°C (662ºF). Excess temperature reduce
tip life.
The tip must be well tinned for good heat
conduction.
Place the tool back on its stand in order to
let it cool down before you store it.
ENGLISH
Ref. 2950200
Ref. 2950100
Ref. 2950110
5 11
-10 Ohms/