Flash Time - Medion LIFE E63063 Mode D'emploi

Other settings in the telephone menu
 PULSE: Select this setting for pulse dialling.

16.3.5. Flash time

Here you can adapt your telephone to the specifications of your network
provider or your PABX. You can set the flash time to the following stages:
LONG, MEDIUM or SHORT.
 Confirm FLASH TIMEwith OK.
 Select a flash time and confirm with OK.
Older telephone systems typically require MEDIUM.
16.3.6. System PIN
Certain settings can only be changed after you have entered the PIN (personal
password). The factory setting for the PIN is "0000".
NOTE!
You can specify your own four-digit PIN here. Please note that the
system PIN is also needed for the reset function. The system PIN
itself is not reset to the default setting. Therefore, write down your
new system PIN and save it in a safe location. If you do, however,
forget your system PIN, please call our customer service.
 Confirm CHANGE PIN with OK.
 Enter the old PIN and confirm with OK.
 Confirm NEW PIN with OK.
 Enter the new PIN and confirm with OK.
 Enter the new PIN again and confirm with OK.
The new PIN is now saved.
16.3.7. ECO Mode
ECO mode enables low-radiation operation during a call. The reduction in
radiation will depend on the distance of the handset from the base.
How to switch the function on or off:
 In the BS SETTING menu, select the option ECO MODE and
confirm with OK.
 Use the  or  keys to switch this function on or off.
 Confirm with OK.
16.3.8. Full ECO
The Full ECO function completely disables the telephone's transmission
power when in standby mode. Full ECO is only possible when the handset is
inserted in the base station.
How to switch the function on or off:
 In the BS SETTING menu, select the option FULL ECO and confirm
182 of 190