Troubleshooting - IKEA FORDELAKTIG 504.494.03 Mode D'emploi

ENGLISH

Troubleshooting

Error code Description
No Function
ER 03 and
Control panel turns
continuous
off after 10 sec.
tone or
ER 03 and
Control panel turns
continuous
off after 10 sec.
tone
Extractor motor is
Extractor
still on.
control panel
ER20
ER22
ER30
ER36
ER39
Disconnect the hob extractor from the power supply.
ER47
Wait a few seconds then reconnect the hob extractor to the power supply.
U400
If the problem persists, call After Sales Service and specify the error code that appears on
E/2
the display.
E/A
E/4
E/6
E/7
E/8
E/9
If there is a fault try to solve the problem by
following the troubleshooting guidelines. If the
problem cannot be solved contact After Sales
Service. You can find a full list of IKEA
appointed contacts at the end of this user
manual.
Possible cause of error
Wrong connection to the mains
or shortcircuit
Continuous sensor activation
detected. Water or cookware on
the glass over the control panel.
Continuous sensor activation
detected. Water or cookware on
the glass over control panel of
the extractor.
Remedy
Disconnect the hob extractor from
the power supply.
Adjust the power supply
connection according to
"ELECTRICAL CONNECTION"
paragraph if needed.
If error persists, please contact
After Sales Service and specify the
problem.
Remove water or cookware from
glass and control panel.
Turn off the hob extractor
Remove water or cookware from
glass and control panel.
Touch again the control panel of
the extractor.
If you operate the appliance wrongly, or the
installation was not carried out by an
authorised installer, the visit from the After
Sales Service technician or dealer will not be
free of charge, even during the warranty
period.
20