stayer RO125 Instructions D'emploi page 19

A sanding sheet that has been used for metal should not
be used for other materials.
Use only original STAYER sanding accessories.
Rough Sanding
Attach a sanding sheet with coarse grain.
Apply only light pressure to the machine so that it runs at a
higher stroke rate and high material removal is achieved.
Fine Sanding
Attach a sanding sheet with fine grain.
By lightly varying the application pressure or changing the
orbital stroke rate, the sanding plate stroke rate can be
reduced whereby the orbital action is maintained.
With moderate pressure, move the machine in a circular
pattern or alternately in lengthwise and crosswise directions
over the workpiece. Do not tilt the machine to avoid sanding
through the workpiece (e. g. when sanding veneer).
After finishing the working procedure, switch the power
tool off.
Polishing
Note: For polishing, the extraction outlet piece 12 can be
removed for easier handling of the machine and to prevent
damage to the workpiece.
For the polishing of weathered paint or buffing out scratches
(e. g., acrylic glass), the machine can be equipped with
appro- priate polishing accessories such as lamb's wool
bonnet, polishing felt or sponge (accessories).
Select a low stroke rate (setting 1 – 2) for polishing in
order to avoid excessive heating of the surface.
Apply the polish onto a somewhat smaller surface than
you intend to polish. Work the polishing agent in with a
suitable polishing tool applying it crosswise or with circular
motion and moderate pressure.
Do not allow the polishing agent to dry out on the surface,
otherwise the surface can become damaged. Do not
subject the surface to be polished to direct sunlight.
Clean the polishing accessories regularly to ensure good
polishing results. Wash out polishing accessories with a
mild detergent and warm water; do not use paint thinner.
Maintenance and service instructions
Cleaning
Before any work on the machine itself, pull the mains
plug.
For safe and proper working, always keep the machine
and ventilation slots clean.
If the replacement of the supply cord is necessary, this
has to be done by STAYER or an authorized STAYER
service agent in order to avoid a safety hazard.
Changing the sanding pad 5 examine whether the retainer
4 is impaired or felt 3. Please replace a deteriorated into a
retainer 4 STAYER service.
ENGLISH
19
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an aftersales service centre for STAYER
power tools.
Repair service
Our after-sales service responds to your questions
conceming maintenance and repair ofyour product as well
as spare parts.
Exploded views and information on spare parts can also
be found under: info@grupostayer.com
Our customer consultants answer your
conceming best buy, application
productsand accessories.
Disposal and recycling
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
OnlyforEC countries:
Do not dispose of power tools into
household waste!
According the European Guideline 2012/19/
UE for Waste Electrical and Electronic
Equipment
national right,power tools that are no longer
usable must be collected separately and disposed of in an
environmentally correct manner.
Subject to change wlthout notlce.
19
questions
and adjustment of
and its implementation into