Norcold N109 Serie Manuel D'installation page 14

- Remove and save the screw [41] from the front box [68] (See
Art00983).
- Pull the front box away from the refrigerator and out from under
the controls [69].
- Reverse the front box and put it on the opposite side of the
controls.
- Attach the front box to the refrigerator with the screw [41] that
was removed before.
- Put the strike plate on the opposite side of the refrigerator
[65b].
- Put the two screws into the holes that are beside the strike
plate.
5. Change the position of the door handles and the door hinges
(See Art01695 and Art00985):
- Remove the plastic cap that is opposite the upper hinge of the
upper door.
- Remove the cap screw [72] from the door handle [70] and the
door hinges [73].
- Remove the round head screw(s) [41] and door handle from
each door.
- Remove the upper hinge of each door.
- Put each of these hinges on the other side of the door as the
lower hinge.
- Attach each of these hinges with the cap screws that were
removed from the other side.
- The recommended torque for each cap screw [72] is 35 in.-lbs.
- Remove the lower hinge of each door.
- Put each of these hinges on the other side of the door as the upper hinge.
- Attach each of these hinges with the cap screws that were removed from the other side.
- Reverse each door handle and put the lower door handle on the upper door and the upper
door handle on the lower door.
- Attach each door handle with a cap screw [72] and two screws [41].
- Put the plastic cap into the hole that is opposite the upper hinge of the upper door.
Installation Manual 14
41
210
212
211
41
69
Art00983
212
Art01683
68
41