Norcold N109 Serie Manuel D'installation page 12

5. Change the position of the door handles (See Art01727):
- Remove the screw(s) [41] and door handle [10] from each door.
- Reverse each door handle and put the lower door handle on the upper door
and the upper door handle on the lower door.
- Attach each door handle with the screws.
6. Install the upper mounting flange and the lower mounting flange in the original
positions (See Art01683):
Make sure that both foam pads [212] remain in
!
WARNING
position on each mounting flange to complete the
combustion seal. If the seal is not complete, exhaust
fumes can be present in the living area of the vehicle.
The breathing of exhaust fumes can cause dizziness,
nausea, or in extreme cases, death.
- Make sure that both foam pads [212] remain in position on each mounting
flange to complete the combustion seal.
- Attach the upper mounting flange [210] and the lower mounting flange [211]
with four screws [41].
The lower mounting flange has more bends than the upper
NOTICE
mounting flange.
- Securely tighten the screws.
7. Reinstall the doors (See Art01731):
- Turn the lower hinge pins into the lower cabinet hinges [67].
To prevent damage to the threads of the hinge pins, turn the
NOTICE
hinge pins by hand until tight and then tighten with a screwdriver.
Apply Loctite removable thread locker (blue) to the threads of the
!
CAUTION
hinge screws before assembly to prevent loosening during use.
Do not allow Loctite to contact any of the plastic surfaces of the
refrigerator because it can damage those surfaces.
- Put each door down onto the lower hinge pin.
- Align the holes in the upper hinges and hold in this position.
- Turn the upper hinge pin into the upper hinge [66] of each door.
- Tighten the hinge pins.
- Put the storage bins in the doors.
8. To install the upper and lower trim pieces refer to the "Install the Refrigerator" section of
this manual.
Installation Manual 12
250b
41
65a
251b
Art01685
Art01727
41
250a
251a
65b
250a
250b
41
70