CARLO GAVAZZI WM40-96 Manuel D'instructions page 5

CARLO GAVAZZI
A u t o m a t i o n C o m p o n e n t s
01
02
03
I I N N T T R R O O D D U U C C T T I I O O N N T T O O W
a
b
c
d
e
4
5
6
7
f
g
W M M 4 4 0 0
HOW TO SET THE VALUES
With WM40 the values setting is even more simple, it is possible to increase or decrease every single digit,
it is possible to easily obtain the wished value or change directly from one multiplier to another one.
Example: use of the menu relevant to the current ratio.
01
During the programming phase the instrument provides useful information:
a
recognition of the programming mode;
b
identifier number of the menu (see also the programming flow chart);
c
edit, identification of the line subject to set;
d
cursor that identifies the digit subject to set;
e
maximum and minimum limit of selectable variable.
02
Use the keys 6 to increase and decrease the digit detected by the cursor (d). To set another digit move
the cursor to match the wished digit using the key 4, every key press corresponds to a left shifting of the
cursor (d).
03
When the last digit on the left is matched by the cursor (d), a further press of the key
change the decimal point and the multiplier
that the instrument is able to do this function.
To modify the decimal point position and the multiplier use the keys
To confirm the set value press the key 7.
To cancel the operation in progress and come back to the starting condition press the key 5.
To cancel the operation in progress and come back to the measuring "Home" page, press and keep press-
ing the key 5 at least 2 seconds.
(f) (k o M), the blinking "dP" (decimal point) text
6 to have the wished value.
4
4 allows to
(g) identifies