Switching The Device On And Off; Attaching The Device; Operating The Device - Flex ALP 3 Notice D'instructions

Switching the device on and off

Note
The switch (3) is both an On/Off switch and a compensation clamp
for the self-levelling device.

Attaching the device

Note
For optimum results it is recommended to attach the device to a tripod.
The device can be mounted directly on a commercially available
camera tripod or unipod with the ¼" thread (5).
14
Switch on the device:
Rotate the switch clockwise
to (ON).
.
Switch off the device:
Rotate the switch anti-
clockwise to (OFF).

Operating the device

Position the device or attach it to the tripod.
Switch on the device.
The device levels itself within the self-levelling range (±3.5°).
Note
If the device has been positioned at too steep an angle (>3.5°),
a warning signal sounds and flashing laser beams are displayed.
In this case:
Move the device into a more horizontal position.
On completion of work:
Switch off the appliance.
ALP3
The device can be attached to
magnetic surfaces with the
installed magnetic clamps (6).