Maintenance And Care; Disposal Information - Flex ALC 2/1-G Notice D'instruction D'origine

The most important operating steps are
explained at the end of these instructions on the
illustrated pages.
See from page 150.
Battery charging with USB cable and
USB charger .............................................. 150
Switching the device on and off ................ 152
Selecting the operating mode ................... 154
Switching over ambient mode .................. 156
Handling the laser ..................................... 158
Testing the horizontal beam ..................... 160
Testing the vertical beam .......................... 164
Checking precision
It is recommended to check the device regularly
to ensure that it is always precise.
If the precision deviates from the permitted
tolerance range, the device must be taken to
a customer service workshop authorised by
the manufacturer.
Have the device adjusted by authorised
technicians only.
The steps required to check the precision are
explained at the end of these instructions on the
illustrated pages. See from page 160.

Maintenance and care

Observe the following instructions:
– Handle the device with care and protect it from
impacts, vibrations, extreme temperatures.
– When the device is not in use, keep it in the
protective pouch.
– Clean the lens with a soft, dry cloth only.
– Have the device repaired by qualified
technicians and with original spare parts only.
This ensures that the safety of the device is
maintained.

Disposal information

EU countries only:
Do not throw electric power tools into the
household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and Electronic
Equipment and transposition into national law
used electric power tools must be collected
separately and recycled in an environmentally
friendly manner.
FLEX ALC 2/1-G
15