Zodiac AquaPure EI 1APURE35C Guide D'installation Et D'utilisation page 22

English
Page 22
4.6.4 how to Add salt to the Pool
1. Turn on pump to circulate pool water.
2. IMPORTANT - Turn the power pack off by
pressing the ON/Off button (OFF will be
displayed on the screen).
3. Test the water for salinity level using test
strips, electronic meter, or by your local pool
professional.
4. Use the Table 1 to determine the amount of salt
to add. Be conservative when adding salt as it is
easier to add more if needed than it is to dilute
if there is too much salt.
5. Broadcast salt into pool. Do not add through
skimmer, main drain, or surge tank. Brush the
salt around the pool to facilitate dissolving.
Circulate filter system for 24 hours to ensure
even distribution.
6. After 24 hours, verify correct salt reading
by testing the water salinity level using test
strips, electronic meter, or by your local pool
professional.
7. When the salinity level is correct, turn the
power pack on. Press the OUTPUT button to set
the desired production rate.
For a new pool or newly resurfaced pool it is
nOTE
recommended to wait at least 30 days (surface
should be completely cured) before adding salt.
Follow the pool surface manufacturers guidelines for
your particular pool. For vinyl and fiberglass pools,
salt can be added at start up.
Zodiac AquaPure Ei Series APURE35C
® ®
|
Installation and Operation Manual