Start The Timer - Rollei 28009 Mode D'emploi

24
After all settings are finished, press the SET button (3)
again and all settings are saved. The „SET" symbol on
the display also will disappear.
The new settings will be used until the battery is
removed or the battery is empty
Display panel (timer starts)
It flashes when the
timer is started
Speaker and release indicator light
Below image shows when the delay time is 5s, exposure time is 4s, interval time is 5s, the speaker of the timer
and focus / release indicator light will work.
Orange indicator light
Blue Indicator light
ENGLISH
Speaker
Focus
Release
0 1 2 3 4 5

5.3 Start the timer

After pressing the TIMER START/STOP button (5),
the timer will start and the display panel will flash
„TIMER ACTIVE" (21). Between the interval shots, the
display panel will continue to display the remaining
time before the next photo is taken. The focus signal
is active 2 seconds before the shutter will be released,
the focus and release lights are indicated in orange.
When the shutter is turned on, the display panel
shows the remaining time before the shutter closes.
Focus and release is indicated by the blue light. If the
speaker is turned on, the timer will beep at 1 second
intervals. After each photo is taken, the remaining
number of shots will be updated.
The shutter is closed, this indicates the
remaining time before the next shot will be
taken.
The shutter is open, this indicates the
remaining time before the shutter is closed.
Remaining numbers of pictures taken.
It flashes when the shutter is released.
6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27